Indicator stainless IP68 multifunction

Easy to programme and use, versatile and high performing weight indicator. The wide range of available functions and interfaces, make it suitable for multiple industrial and commercial weighing applications, such as floor scales, mobile weighing, etc. Case in IP68 stainless steel. CE-M approvable (OIML R-76/EN 45501)

• Waterproof keypad.
• LCD 25mm backlit display with 6 high contrast digits and icons for indication of active functions.
• Waterproof IP68 STAINLESS STEEL case, easy to clean and resistant in harsh and corrosive environments.
• Dimensions in mm: 243x145x78,4 mm.
• Suitable for use on the table, column, or wall.
• A/D 24 bit converter, 4 channels, up to 200 conv./sec. autoselect and up to 8 signal linearisation points.
• Up to 10.000e or multirange 3 x 3000e @ 0,3 µV/d in approved version for CE-M legal for trade use.
• Up to 1.000.000 displayable divisions with built-in resolution up to 3.000.000 points.
• Connection with up to 8 load cells with input resistance equal to 350 Ohm or up to 16 cells of 700 Ohm each.
• Digital calibration and set-up from keypad or from PC with DINITOOLS.
• Power supply 110-240 Vac.

• X 10 high resolution visualisation
• Net/Gross or lb/kg conversion
• Weighs totalisation
• Formulation
• +/- Check
• Percentage weighing
• Counting (max. counting resolution of 1.500.000 divisions)
• Input/Output
• Hold and Peak
   
• RS232/C bidirectional port on RJ connector (or USB optionally) for quick connection, configurable for PC, PLC, additional remote display.
• RS232/C bidirectional port for connection to printer or labeller.
• IR input for remote control management.

NOTE! Peak/Hold firmware must be ordered when ordering, it can't be added afterwards.

• CALIBRATION VIDEO:                                                                           

    

  ZERO CALIBRATION ONLY:

  

•  

•